Follow

Topaz Signature Pads - Installation and configuration

If you're located in a state or country that requires signature pads for patient verification, there are some additional setup steps required.

 

Please note: This install process only works on Windows computers, the signature pad drivers are not available on Mac systems.

  1. Go to Topaz Sigweb and download the version for pad models ending in -HSB-R, -BHSB-R and -B-R, as below.
  2. Once the file has finished downloading, go ahead and run it.
  3. After clicking next once in the installer, you'll be presented with a screen asking you to choose the model of signature pad, select the model that corresponds with the beginning of the model of pad you're using and click "OK."
  4. On the next screen, you'll then select the specific model of signature pad you're using and click "OK."
  5. On the next screen, you'll select "HSB (USB type)" and hit "OK" one last time

    .

  6. On the last page, simply select "Agree" and the installation will start.
  7. Once the installation has been completed, everything is set up to capture signatures in MJ Freeway.
Was this article helpful?
0 out of 0 found this helpful
Have more questions? Submit a request

Comments